Several problems should be noticed in the selection of aeration fan for sewage treatment:

1,、根據實際情況計算參數

1. Calculate parameters according to actual conditions

在污水廠選擇污水處理曝氣風機，廠家產品樣本提供的都是標準進氣狀態的性能參數,，但風機實際使用時不是標準狀態,，風機的環境條件(如溫度,、大氣壓力、海拔等)不同時,，風機的性能也會發生變化,。設計選擇時不能直接使用產品樣本的性能參數，相反,，根據實際使用狀態,，風機的性能要求必須轉換為標準進氣狀態的風機。

When the sewage treatment aeration fan is selected in the sewage treatment plant, the performance parameters provided by the manufacturer's product samples are all in the standard intake state, but the actual use of the fan is not in the standard state. The performance of the fan will also change when the environmental conditions of the fan (such as temperature, atmospheric pressure, altitude, etc.) are different. The performance parameters of the product sample cannot be directly used in the design selection. On the contrary, according to the actual use status, the performance requirements of the fan must be converted to the standard intake status of the fan.

2,、出口壓力的影響因素分析

2. Analysis of influence factors of outlet pressure

容積鼓風機排氣壓力的高低并不取決于鼓風機本身,，而是由氣體從鼓風機排出后的裝置，即所謂的“背壓”來決定,，污水處理曝氣風機具有強制氣體輸送的特點,。

The exhaust pressure of the volumetric blower is not determined by the blower itself, but by the device after the gas is discharged from the blower, namely the so-called "back pressure". The sewage treatment aeration fan has the characteristics of forced gas transmission.

鼓風機銘牌上顯示的排氣壓力是風機的額定排氣壓力，實際上,，鼓風機可以在低于額定排氣壓力的所有壓力下工作,，只要強度和排氣溫度允許，就可以超過額定排氣壓力,。

The exhaust pressure shown on the nameplate of the blower is the rated exhaust pressure of the blower. In fact, the blower can work at all pressures lower than the rated exhaust pressure. As long as the strength and exhaust temperature allow, the rated exhaust pressure can be exceeded.

污水處理廠的情況是,，排氣系統產生的壓力(背壓)是管道系統的壓力損失值、曝氣池水深和環境大氣壓力的總和,。由于某些原因,，例如，由于曝氣頭或管道堵塞,，管道系統的壓力損失增加,，背壓上升，風機的壓力也會相應增加,。另外,，由于曝氣頭破裂或管道泄漏等原因，管道系統的壓力損失減少,，背壓持續降低,，風機的壓力也降低。

In the case of sewage treatment plants, the absolute pressure (back pressure) generated by the exhaust system is the sum of the pressure loss value of the pipeline system, the water depth of the aeration tank and the ambient atmospheric pressure. For some reasons, for example, due to the blockage of the aerator or pipe, the pressure loss of the pipe system will increase, and the back pressure will rise, and the pressure of the fan will also increase accordingly. In addition, due to the rupture of the aerator or or pipeline leakage, the pressure loss of the pipeline system is reduced, the back pressure continues to decrease, and the pressure of the fan is also reduced.

綜上所述,，在確定污水處理曝氣風機壓力時,，只要風機在標準狀態下能達到的壓力，就等于使用狀態下的大氣壓力,、曝氣池水深和管道損失之和,。

To sum up, when determining the pressure of the sewage treatment aeration fan, as long as the fan can reach the pressure under the standard state, it is equal to the sum of the atmospheric pressure, the depth of the aeration tank and the pipe loss under the use state.

3、鼓風機氣流因素

3. Blower airflow factor

計算污水處理的氧氣需求時,，結果是標準狀態下所需氧氣的質量流量qm(kg/min)轉換為標準狀態下所需空氣的體積流量qv1(m3/min),，如果鼓風機的使用狀態不標準(例如在高原地區使用),，空氣密度、含水量也會發生變化,。

When calculating the oxygen demand of sewage treatment, the result is that the mass flow qm (kg/min) of oxygen required under the standard state is converted to the volume flow qv1 (m3/min) of air required under the standard state. If the use state of the blower is not standard (for example, in the plateau area), the air density and water content will also change.

因此,，需要計算能夠提供相同質量流的體積流，即轉換流qv2,。在高原地區使用時,，環境大氣壓力也會發生變化，壓力相應提高,，鼓風機的泄漏流量qvb會增加,，鼓風機供應的空氣容積流量會減少，氧氣供應也會不足,。

Therefore, it is necessary to calculate the volume flow that can provide the same mass flow, namely the conversion flow qv2. When used in plateau areas, the ambient atmospheric pressure will also change, and the pressure will increase accordingly, the leakage flow qvb of the blower will increase, the air volume flow supplied by the blower will decrease, and the oxygen supply will also be insufficient.

因此,，在設計時，在使用條件發生變化時,，考慮到各種因素的影響,，風機供應的實際氣流必須滿足使用要求，并計算轉換流量qv2和流出流量qvb2,。

Therefore, in the design, when the service conditions change, taking into account the influence of various factors, the actual air flow supplied by the fan must meet the service requirements, and the conversion flow qv2 and outflow flow qvb2 must be calculated.

4,、注意冬天和夏天的差異

4. Pay attention to the difference between winter and summer

風機選型要注意風機供應流量的變化規律。也就是說,，同樣的鼓風機在冬天和夏天容積流量不變,，但流量取決于空氣密度的質量，也就是說氧氣供應量會有所不同,。

Pay attention to the change rule of fan supply flow in fan selection. That is to say, the volume flow of the same blower remains unchanged in winter and summer, but the flow depends on the quality of air density, which means that the oxygen supply will be different.

在標準狀態和使用狀態下,，鼓風機的容積流動不變，但空氣密度,、含水量等發生變化,，冬季溫度降低時，鼓風機傳輸?shù)娇諝獬氐难鯕夤?yīng)增加,，夏季溫度升高時減少,。例如，某污水處理廠在上述計算實例中使用鼓風機,，根據環境溫度的變化計算風機的實際供氧,，而該年的變化規律是，在實際運行過程中,，由于進水、水質,、水溫等參數的變化,，系統需氧量也在夏季變化,，冬季水溫降低，曝氣池的需氧量減少,。這是因為冬季氣溫下降,，空氣密度提高，風機供應的干空氣質量比標準狀態大,，氧氣供應量增加,。從運行的實際測量來看，每年冬天暴露池的溶解氧比夏天高1 ~ 3毫克/L,。

Under the standard and service conditions, the volume flow of the blower remains unchanged, but the air density and water content change. When the temperature decreases in winter, the oxygen supply transmitted by the blower to the air pool increases, and decreases when the temperature increases in summer. For example, a sewage treatment plant uses a blower in the above calculation example to calculate the actual oxygen supply of the blower according to the change of the ambient temperature. The change rule of this year is that during the actual operation process, due to the change of the parameters such as water inlet, water quality and water temperature, the oxygen demand of the system also changes in summer, and the water temperature decreases in winter, and the oxygen demand of the aeration tank decreases. This is because the temperature drops in winter, the air density increases, the dry air quality supplied by the fan is higher than the standard state, and the oxygen supply increases. From the actual measurement of operation, the dissolved oxygen in the exposure pool is 1~3 mg/L higher in winter than in summer.

因此,，在生產運行過程中，必須對這些變化及時調整設備,，使風機的充氧能力適應實際運行中的氧氣需求,。對于污水處理曝氣風機，使用變頻器改變風機速度調整送風氣流是經濟實用的,。

Therefore, in the process of production and operation, the equipment must be adjusted in time for these changes, so that the oxygenation capacity of the fan can meet the oxygen demand in actual operation. For the sewage treatment aeration fan, it is economical and practical to use the frequency converter to change the fan speed and adjust the supply air flow.

以上就是為大家介紹的有關四川水產曝氣設備詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://ailelejlb.com/

The above is the detailed introduction of Sichuan aquatic aeration equipment introduced for you. I hope it can help you. If you have any questions, please contact us. We will provide services for you with our attitude http://ailelejlb.com/