1,、 Roots blower is a commonly used oxygenation equipment in sewage treatment engineering. When selecting the type of fan for sewage treatment plant, the performance parameters given on the fan manufacturer's product samples are under the standard air inlet state. The standard air inlet state of the fan specified in China is: pressure p0=101.3 kPa, temperature T0=20 ℃, and relative humidity φ=  50%, air density ρ=  1. 2 kg/ m3 。

然而風機在實際使用中并非標準狀態,當鼓風機的環境工況如溫度,、大氣壓力以及海拔高度等不同時,風機的性能也將發生變化,設計選型時就不能直接使用產品樣本上的性能參數,而需要根據實際使用狀態將風機的性能要求,換算成標準進氣狀態下的風機參數來選型,。

However, the fan is not in the standard state in actual use. When the environmental conditions of the fan, such as temperature, atmospheric pressure and altitude, are different, the performance of the fan will also change. The performance parameters on the product samples cannot be directly used in the design and selection of the fan. Instead, the performance requirements of the fan need to be converted into the fan parameters under the standard intake state according to the actual use state to select the fan.

二、羅茨風機選型中應關注鼓風機出口壓力影響因素的分析容積式鼓風機排氣壓力的高低并不取決于風機本身,而是氣體由鼓風機排出后裝置的情況,即所謂“背壓”決定的,曝氣鼓風機具有強制輸氣的特點,。

2,、 In the selection of Roots blower, attention should be paid to the analysis of factors affecting the blower outlet pressure. The exhaust pressure of the volumetric blower does not depend on the blower itself, but on the device after the gas is discharged by the blower, which is determined by the so-called "back pressure". The aeration blower has the characteristics of forced gas transmission.

鼓風機銘牌上標出的排氣壓力是風機的額定排氣壓力。實際上,鼓風機可以在低于額定排氣壓力的任意壓力下工作,而且只要強度和排氣溫度允許,也可以超過額定排氣壓力工作,。對于污水處理廠而言,排氣系統所產生的壓力(背壓) 為管路系統的壓力損失值,、曝氣池水深和環境大氣壓力之和,若由于某種原因,如曝氣頭或管路堵塞,使管路系統的壓力損失增加,“背壓”也會升高,于是鼓風機的壓力也就相應升高;又若曝氣頭破裂或管路泄漏等原因,管路系統的壓力損失則會減少“, 背壓”便不斷降低,鼓風機的壓力也隨之降低。

The exhaust pressure marked on the nameplate of the blower is the rated exhaust pressure of the blower. In fact, the blower can work at any pressure lower than the rated exhaust pressure, and can also work beyond the rated exhaust pressure as long as the strength and exhaust temperature allow. For the sewage treatment plant, the pressure (back pressure) generated by the exhaust system is the sum of the pressure loss value of the pipeline system, the water depth of the aeration tank and the ambient atmospheric pressure. If the pressure loss of the pipeline system increases due to some reason, such as the blockage of the aeration head or pipeline, the "back pressure" will also increase, so the pressure of the blower will increase accordingly; In addition, if the aerator breaks or the pipeline leaks, the pressure loss of the pipeline system will be reduced, and the "back pressure" will be continuously reduced, so will the pressure of the blower.

綜上所述,確定曝氣鼓風機壓力時,只需要鼓風機在標準狀態下所能達到的壓力等于使用狀態下的大氣壓力,、曝氣池水深和管路損失之和,。

To sum up, when determining the pressure of the aeration blower, it is only required that the pressure that the blower can reach under the standard state is equal to the sum of the atmospheric pressure under the service state, the depth of the aeration tank and the pipeline loss.

三、羅茨風機選型時應關注鼓風機空氣流量因素在計算污水處理的需氧量時,其結果為標準狀態下所需氧的質量流量qm (kg/ min) ,再將其換算成標準狀態下所需空氣的容積流量qv1(m3/ min) ,如果鼓風機的使用狀態不是標準狀態,例如在高原地區使用,則空氣密度,、含濕量會發生變化,鼓風機所供應的空氣容積流量與標準狀態是相同的,而所供空氣的質量流量將減少,有可能導致供氧量不足,。

3、 Pay attention to the air flow factor of the blower when selecting Roots blower. When calculating the oxygen demand for sewage treatment, the result is the mass flow qm (kg/min) of the oxygen required under the standard state, and then convert it into the volume flow qv1 (m3/min) of the air required under the standard state. If the use state of the blower is not the standard state, such as in the plateau area, the air density and moisture content will change, The air volume flow supplied by the blower is the same as the standard state, but the mass flow of the air supplied will be reduced, which may lead to insufficient oxygen supply.

因此,需要計算出能供應相同質量流量的容積流量,即換算流量,。在高原地區使用時,環境大氣壓力也會發生變化,壓力比相應升高,那么,鼓風機的泄漏流量則會加大,這將導致鼓風機所供應的空氣容積流量減少,也可能造成供氧量不足,。

Therefore, it is necessary to calculate the volume flow that can supply the same mass flow, that is, the converted flow. When it is used in the plateau area, the ambient atmospheric pressure will also change, and the pressure ratio will increase accordingly, so the leakage flow of the blower will increase, which will reduce the volume flow of air supplied by the blower, and may also cause insufficient oxygen supply.

因此,設計時需要考慮使用條件發生變化時各種因素的影響,以保證風機所供應的實際空氣流量能夠滿足使用要求,并需計算出換算流量和泄漏流量。

Therefore, the design needs to consider the influence of various factors when the service conditions change to ensure that the actual air flow supplied by the fan can meet the service requirements, and the conversion flow and leakage flow need to be calculated.

以上就是為大家介紹的有關浙江污水處理羅茨風機的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://ailelejlb.com/

The above is a detailed introduction of Roots blower for Zhejiang sewage treatment. I hope it will be helpful to you. If you have any questions, please contact us. We will provide you with professional services http://ailelejlb.com/